This area is dedicated to our foreign guests of this forum. Contributions can be written in any language.
[Diese Kategorie ist den ausländischen Gästen dieses Forums gewidmet. Beiträge können in beliebiger Sprache verfasst werden.]
Hello,
Is possible to made a overtaking of delayed trains as shown in the picture?
If {type of train is Express} and {late more e.g. 10 min.} and {signal S1 blocked} (by earlier train) then route applies IT-2.
else
route applies IT-1.
No problem to do it, but if train delayed always valid IT-2. I can't addict itenaries IT-1 with S1 because not possible to get requirement (late>1:10 and s=!.... ).
There is a solution?
Best Regards
Pablo hat geschrieben:Hello,
Is possible to made a overtaking of delayed trains as shown in the picture?
If {type of train is Express} and {late more e.g. 10 min.} and {signal S1 blocked} (by earlier train) then route applies IT-2.
else
route applies IT-1.
No problem to do it, but if train delayed always valid IT-2. I can't addict itenaries IT-1 with S1 because not possible to get requirement (late>1:10 and s=!.... ).
There is a solution?
Best Regards
Trains can overtake other trains (e. g. an express train can overtake a freight train), only this solution doesn't depend on delays.
The principle is basically as follows: If Train2 is on time there should be enough distance to Ex1 so it won't be overtaken, if Train2 is running just before Ex1 due to a delay it will be overtaken. So in your example applying the method described would require that you would have to list all express trains in a switch contact (e. g. EX1) and all trains that can be overtaken (e.g. Train2) have to be listed in another. Then you create the itenaries as decribed in the tutorial.
If you need an English version of that part of the tutorial this might take a little time.
Regards,
Sebastian
_________________
Berlin und Umgebung im Jahr 1989
Could you please give me little part sim where its working? Or where to look for it (in working sim). That should be enough for me to start with.
Thank a lot for helping.
Pablo hat geschrieben:Could you please give me little part sim where its working? Or where to look for it (in working sim). That should be enough for me to start with.
Thank a lot for helping.
Pablo hat geschrieben:Thanks. I found it.
By the way - can you tell me: which means "-" at timing point instead route?
"-" and "--" are just routes with no trains assigned. I usually use them to seperate routes for different directions if a timing point, data changing point etc. works both directions to increase clarity.
